Hitachi WH18DBDL2 Instruction Manual page 16

English
(1) Removing the hook.
Remove the screws fi xing the hook with Philips screw
driver. (Fig. 11)
(2) Replacing the hook and tightening the screws.
Install securely the hook in the groove of power
tool and tighten the screws to fi x the hook fi rmly.
(Fig. 12)
7. About Remaining Battery Indicator
When pressing the remaining battery indicator switch,
the red indicator lamp lights and the battery remaining
power can be checked. (Fig. 13)
When releasing your fi nger from the remaining
battery indicator switch, the indicator lamp changes
indication of LED light mode. The Table 5 shows the
state of red indicator lamp and the battery remaining
power.
Switch panel
ON
ON
OFF
Remaining Remaining
battery battery
indicator indicator
lamp switch
16
Groove
Screw
Hook
Fig. 11
Groove
Screw
Hook
Fig. 12
Fig. 13
State of lamp Battery Remaining Power
The battery remaining power is
enough.
The battery remaining power is a half.
The battery remaining power is nearly
empty.
Re-charge the battery soonest
possible.
As the remaining battery indicator shows somewhat
diff erently depending on ambient temperature and
battery characteristics, read it as a reference.
NOTE
Do not give a strong shock to the switch panel or
break it. It may lead to a trouble.
8. How to use the LED light
By pressing the light selector switch on the switch
panel, the LED light mode changes as Table 6. It is
indicated by green lamp. (Fig. 14)
To prevent the battery power consumption, turn off the
LED light frequently.
Switch panel
ON
ON
OFF
Light Remaining
section battery
switch indicator
lamp
Always-ON
mode
Panel
display
Always ON
State (turn off after
2 minutes)
Table 5
Fig. 14
Table 6
SW Always-OFF
interlocked mode
mode
Light only Always OFF
SW-ON