Table of Contents
Advertisement
(2) If already using computers for wireless
transmission (Ad Hoc mode)
Use the existing wireless cards for the computers to carry out direct
wireless communication with the projector in Ad Hoc mode.
Computer
Setting procedure
Set the computer and the projector according to the following procedure.
Preparation &
settings
<Projector>
Inserting the
wireless card (page
18)
LAN settings (page
21)
Setting example
Setting item
IP ADDRESS
SUBNET MASK
MODE
CHANNEL
Note:
• The computer settings can be used without further changes. However, if
using the WEP function, communication with the projector will not be
possible. You will first need to turn off the WEP function for all computers
which are to communicate with the projector.
Furthermore, when the WEP function is turned off, the data encryption
function will also be turned off, so it is recommended that you use a
feature such as the Sharing Settings for folders to set password
protection for your data. Ask your network administrator for further
details.
• If you any wireless cards other than the optional ET-CDWL1 series,
correct operation cannot be guaranteed.
Projector
Check communication
<Computer>
Use Wireless
Manager to check
communication with
the projector (page
40)
Projector LAN settings
Set the computer IP address to an address with the
last number different.
e.g. If the computer IP address is 192.168.10.11, set
the projector's address to something like
192.168.10.12.
Use the same setting for the computer.
AD HOC
Use the same setting for the computer.
-15-
Computer
Transmit
images
<Computer>
Use Wireless
Manager to
transmit the
images (page
41)
Advertisement
Table of Contents
