Panasonic PT-L712NTE Operating Instructions Manual page 23

Commercial use

Hide thumbs Also See for PT-L712NTE:

Table of Contents

$ $ $ $ MODE

This can be set to either "AD HOC"

or "INFRASTRUCTURE". If using

methods (1) or (2) as described on

page

of "Wireless function

preparation", set to "AD HOC". If

using method (3) in "Wireless

function preparation", set to

"INFRASTRUCTURE".

Use the I or H button to change

the setting, and then press the

ENTER button.

Some of the settings used differ between AD HOC mode and

INFRASTRUCTURE mode.

% % % % Channel

This lets you set the channel. You must set the channel to the

same channel that is being used by the wireless card of the

transmitting computer.

In INFRASTRUCTURE mode, operation is usually possible

regardless of the settings used. However, for some access points,

you may need to set the channel to the same channel that is used

by the access point, otherwise communication may not be possible.

Use the I or H button to change the setting, and then press the

ENTER button.

Note:

• The channels that can be used will vary depending on the

country (page 5).

AD HOC

C H

1 1

-23-

M O D E

A D

H O C

I N F R A S T R U C T U R E

INFRASTRUCTURE

S E T U P

Table of Contents