Table of Contents
Advertisement
AD HOC
In Ad Hoc mode, make the "IP
& & & &
ADDRESS" setting in step
( below.
( ( ( ( IP ADDRESS
This lets you set the projector's IP address.
Refer to page
this setting. However, the projector's IP address cannot be the
same as the IP address that is being used by the transmitting
computer.
Use the F or G button to change the number position, and use the
I or H button to set the numbers. When you have finished, press
the ENTER button.
14
of "Wireless function preparation" while making
S E T U P
I P
A D D R E S S
1 9 2 . 1 6 8 .
-24-
INFRASTRUCTURE
SSID
If using Infrastructure mode,
change the "SSID" setting to the
same SSID for the access point
that will be used for
communication. However, the
projector's SSID can be up to 16
characters in length, and must
consist of capital letters (A-Z)
and numerals (0-9).
Accordingly, if the SSID that has
been set for the access point is
invalid as an SSID for the
projector, ask your network
administrator to change the
access point's SSID to one that
can be used by the projector.
Use the F or G button to
change the characters, and use
the I or H button to change
the character position. When
you have finished, press the
ENTER button.
S E T U P
S S I D
S S I D
1 0 .
1 0
Advertisement
Table of Contents
