Accessories; Standard Accessories; Optional Accessories - Hitachi H 60MEY Instruction Manual

English
WARNING:
ALWAYS use Only authorized HITACHI replacement parts and accessories. NEVER use replacement parts
or accessories which are not intended for use with this tool. Contact HITACHI if you are not sure whether it
is safe to use a particular replacement part or accessory with your tool.
The use of any other attachment or accessory can be dangerous and could cause injury or mechanical
damage.
NOTE:
Accessories are subject to change without any obligation on the part of the HITACHI.

STANDARD ACCESSORIES

(1) Bull Point (SDS max shank) (Code No. 313471) .....1
(2) Case (Code No. 326511) ........................................1
(3) Side Handle (Code No. 317103) .............................1
OPTIONAL ACCESSORIES .......... sold
separately
○ Demolitioning
(1) Bull Point (SDS max shank type)
Overall Length 11-1/32" (280 mm) 15-3/4" (400 mm)
Code No. 313471
○ Groove digging and edging
(1) Cold chisel (SDS max shank type)
Overall Length 11-1/32" (280 mm) 15-3/4" (400 mm)
Code No. 313473
○ Asphalt Cutting
(1) Cutter (SDS max shank type)
Overall Length
Code No.
12

ACCESSORIES

313472
313474
15-3/4" (400 mm)
313475
○ Scooping Work
(1) Scoop (SDS max shank type)
Overall Length
Code No.
○ Surface Roughing
+
(1) Bushing Tool
(Code No. 313477)
○ Tamping
+
(1) Rammer
(Code No. 313478)
○ Hammer Grease A
30 g (in a tube) (Code No. 981840)
70 g (in a tube) (Code No. 308471)
NOTE:
Specifi cations are subject to change without any obligation
on the part of the HITACHI.
15-3/4" (400 mm)
313476
(2) Shank
(Code No. 313479)
(2) Shank
(Code No. 313479)