Operation; Maintenance - Makita 6802BV Instruction Manual

OPERATION

Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
CAUTION:
When fitting the screw onto the point of the bit, be
•
careful not to push in on the screw. If the screw is
pushed in, the clutch will engage and the screw will
rotate suddenly. This could damage a workpiece or
cause an injury.
Use the proper bit for the head of the screw that you
•
wish to use.
Do not continue unnecessary clutching operation.
•
NOTE:
Make sure that the bit is inserted straight in the screw
head, or the screw and/or bit may be damaged.
When using insert bit
1
2
3
004184
Fit together the insert bit and magnetic bit holder. Install a
locator assembly for an insert bit.
Then adjust depth setting. Initially, adjust the locator
assembly to create a distance of approximately 1 mm
from the tip of the locator to the base of the screw head.
Continue adjusting until the proper depth setting is
obtained by following the method of "Depth adjustment".
To remove the bit, pull the magnetic bit holder firmly. Hold
the magnetic bit holder in your hand and grasp the bit
with a pair of pliers. Pull the bit out of the magnetic bit
holder. Sometimes, it helps to wiggle the bit with the
pliers as you pull.
1 mm
004185
1. Locator
2. Insert bit
3. Magnetic bit
holder
6

MAINTENANCE

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Phillips Insert bits
•
Magnetic bit holder
•
Magnetic socket bit
•
Locator
•
Plastic carrying case
•
or attachments
Only use accessory or
are