Transport Wheels (Optional); Grass Catcher - Jacobsen Eclipse 126 Technical Manual

4.6

TRANSPORT WHEELS (OPTIONAL) __________________________________________

!
WARNING
Always engage parking brake and disconnect power
connector before installing or removing the transport
wheels.
Transport wheels are an optional accessory available
through your Jacobsen Dealer. Traction wheels are
recommended when not using the Mower Caddy to move
the mower from green to green.
1. Push and hold the kickstand against the ground then
pull the mower handle, by the lift point, back until the
mower rests on the stand (S).
2. To remove wheels, press retaining clip (T) away
from hub, and pull wheel off hub.
3. To install wheels, press retaining clip (T), place
wheel on hub, and turn the wheel backwards until
studs on back of wheel line up with holes in hub (U).
Push wheel in and release clip.
4.7

GRASS CATCHER _________________________________________________________

1. When the basket is about two thirds (2/3) full of grass
clippings, move the mower off the green.
2. Stop on a flat surface, disengage O.P.C. bail,
engage parking braket, turn key switch OFF, and
disconnect power connector.
3. Remove and empty the grass clippings from the
mower.
!
To prevent serious injury, always disengage
O.P.C. bail and disconnect power connector
before emptying grass catcher.
WARNING
4. Always disengage reel switch prior to transporting
the mower more than a few feet.
5. Push the mower forward off the kickstand, start the
unit, and engage the O.P.C. bail.
6. When using a vehicle to transport the mower, apply
parking brake, turn key switch OFF, and disconnect
power connector.
OPERATION
U
S
T
Figure 4E
en-29
4