Chapter 4. Initializing the RackSwitch
When you supply power to the RackSwitch, the switch initializes automatically.
DANGER
(L003)
or
The following LEDs indicate the overall system status:
v Power Supply: Steady green if both power cords are connected, flashing green if
v Service ( ! ): Off if the system is OK, flashing if service is required.
Use the mini-USB console cable to connect the RS-232 serial port on the switch
unit front panel to a terminal or a computer running a terminal emulation program.
You can access the command-line interface to perform initial configuration tasks.
© Copyright IBM Corp. 2014
Multiple power cords. The product might be equipped with multiple power
cords. To remove all hazardous voltages, disconnect all power cords.
1
2
!
1
2
only one power cord is connected.
49