Advertisement
Table of Contents
MODEL CP-250
RADIO PREPARATION:
1. Select two of the five mounting tabs provided and match the radio mounting style of the vehicle accord-
ing to Figures 1 through 3 below.
NOTE: Tab number is stamped on bottom of tab.
2. Attach the mounting tabs to the radio chassis with the two M4 X 5 screws provided.
3. Attach the 14-pin connector harness provided to the radio.
FIG. 1
TAB #1
M4 SCREW
FIG. 2
TAB #3
M4 SCREW
FIG. 3
TAB #4
M4 SCREW
INSTALLATION GUIDE FOR:
CHRYSLER, PLYMOUTH,
& DODGE VEHICLES
Printed in Korea
Form No. 128-4729A
TAB #2
M4 SCREW
TAB #2
M4 SCREW
M4 SCREW
TAB #5
Advertisement
Table of Contents
Related Manuals for Audiovox CP-250
Summary of Contents for Audiovox CP-250
- Page 1 MODEL CP-250 RADIO PREPARATION: 1. Select two of the five mounting tabs provided and match the radio mounting style of the vehicle accord- ing to Figures 1 through 3 below. NOTE: Tab number is stamped on bottom of tab. 2. Attach the mounting tabs to the radio chassis with the two M4 X 5 screws provided.
- Page 2 RADIO INSTALLATION: 1. Remove dash panel from vehicle to expose sub-dash. 2. Remove and discard radio dummy panel attached to sub-dash. NOTE: Do not discard hardware for dummy panel. 3. Pre-wire radio including antenna wire. Attach ring lug on ground wire (black w/white stripe) from radio harness side and the vehicle side grounding strap to the rear of the radio chassis using the M5 x 8 screw provided.
Need help?
Do you have a question about the CP-250 and is the answer not in the manual?
Questions and answers