Rinnai rhfe-551ft Installation Insrtuctions page 4

1 CUSTOMERS OPERATING INFORMATION
H IGNITION
(Not using Timer)
Make sure the timer is in the "ON"
position.
n To Ignite Main Burner
Push the main switch down to switch it
"ON".
ON
* -
OFF 1
0
The green indicator lamp will glow.
The heater will light in about 15 seconds,
and the red indicator lamp will glow.
If the heater does not light, check that the
temperature control is set to a high enough
setting.
TEMPERATURE
.
n To Increase Room Temperature
Slide the temperature control towards the
"HI" position. The burner has 3 settings,
"OFF", "LO"; "HI" and will automatically
modulate between these settings to keep
the room temperature constant. It is quite
normal for the burner to go out auto-
matically during operation. When the
burner goes out, the red combustion lamp
goes out, but the green operation lamp
stays alight.
The fan speed will also modulate according
to the room temperature.
TEMPERATURE
n To Decrease Room Temperature
Slide the control towards the "LO"
position.
The heater may go out completely, and
come on again when the room temperature
has dropped to the selected level.
TEMPERATURE
-2-