Rinnai rhfe-551ft Installation Insrtuctions page 18

5. Check rubber seal is in place on
terminal.
Terminal Seal
*For weather board walls, add spare
rubber seal provided to compensate for
weather board angle.
6. Installation of Terminal
From outside, insert terminal into sleeve
with the "A" mark at the top.
Left hand side fixing tie is marked
"LEFT" (from inside).
Pull hard on left and right hand side
You should be able to pull the ties 2 or
3 slots past the starting point.
Cut the ties, leaving about 20 mm past
the lugs. Bend ties so they are parallel
with the wall.
8. Insert Inner Connection Assembly
Push assembly into terminal tube, make
sure "TOP" mark is uppermost. Fix
Sleeve
attaching.
- 16-