Installation; Sleep; High Altitude Mode; Lamp Power - Panasonic PT-AE3000E Operating Instructions Manual

OPTION menu

INSTALLATION

When installing the projector, select the projection
method according to the projector position. Press I H
to cycle through the options. See "Projection method" on
page 15.
FRONT/DESK
FRONT/CEILING
REAR/DESK
REAR/CEILING

SLEEP

You can select the required duration of time and set the
off timer to turn off the power of the projector
automatically. 3 minutes before turn-off, the countdown
of minutes will be displayed in the lower right corner.
Press I H to cycle through the options.
OFF
60MIN.
90MIN.
120MIN.
E
44 - NGLISH
Setting on a desk/floor and
projecting from front
Mounting on the ceiling and
projecting from front
Setting on a desk/floor and
projecting from rear
Mounting on the ceiling and
projecting from rear
240MIN.
210MIN.
180MIN.
150MIN.

HIGH ALTITUDE MODE

If you use the projector at high elevation, the HIGH
ALTITUDE MODE setting need to be ON to set the fan
speed high. Press I H to select the required option.
OFF The fan speed is low.
ON The fan speed is high.
NOTE:
• At 1 400 - 2 700 m (4 593 - 8 858 ft) above sea level,
the setting must be ON.
• The loudness of fan noise depends on the HIGH
ALTITUDE MODE setting.

LAMP POWER

You can adjust the power of the lamp to save on
electricity, prolong the lamp life and reduce the noise.
Options
When higher luminance is
NORMAL
required.
When lower luminance is
ECO-MODE
sufficient.
NOTE:
• When no input signal is detected, the function is
disabled.

LAMP RUNTIME

You can check how long the lamp has been used.
NOTE:
• LAMP RUNTIME is a relevant matter for lamp
replacement timing. See "Replacing the lamp unit" on
page 47.
Function