Assembly; Operations; Before You Clean; Pre-Treating - Bissell powerforce 76R9 SERIES User Manual

A
ssembly
1. slide upper body onto lower body.
2. secure with screws.
3. slide handle assembly into upper body,
until it will not go any further. (screw
hole should be facing the back of the
unit before sliding it into place)
4. secure with screw.
5. Place solution tank on back of unit.
O
perations

Before you clean

1. move furniture to another area if clean-
ing an entire room. (optional)
2. Vacuum carpet thoroughly.
3. Plan your cleaning route to leave an
exit path. it is best to begin cleaning in
the corner farthest from your exit.
Pre-Treating (optional)
Pre-treat stubborn stains and highly
soiled carpet in hallways and other
high-traffic areas.
1. generously spray bissell tough stain
pre-cleaner evenly over soiled area.
Caution: DO NOT OVERWET
CARPET
2. Wait 3-5 minutes before deep cleaning.
Fill the tank
1. Remove the solution tank by lifting it
straight up, then away from the lower
body.
2. unscrew the black cap at the bottom of
the solution tank.
3. fill to the foRmula line with bissell
2X formula. fill the rest of the tank with
hot (not boiling) tap water to the water
fill line. Replace and tighten the black
cap.
4. Place solution tank on lower body.
w w w . b i s s e l l . c o m
1.
3.
5.
WARNING:
To reduce the risk of fire, use
only BISSELL advanced deep
cleaning formula for full size
machines in your deep cleaner.
Use of cleaning formulas that
contain lemon or pine oil may
damage this appliance and void
the warranty. Chemical spot
cleaners or solvent-based soil
removers should not be used.
These products may react with
the plastic materials used in your
deep cleaner causing cracking
or pitting.
2.
8 0 0 . 2 3 7 . 7 6 9 1
2.
4.
Tip:
always vacuum
thoroughly before
you deep clean.
if possible, move
large furniture to
an area you will
not be cleaning.
5