Tail Assembly - Oxy Heli Oxy 3 Instruction Manual

Tail Pitch Slider Assembly. (Box 02 / Bag 1)
Step 1
OXY0061
Tail Pitch Slider Ring
2 X OXY0139
Shim 7x8x0.1
OXY0060
Tail Slider Bushing
Important Note:
This part, for tuning reasons,
comes factory pre assembled
with grease and loctite. It is
ready to use.
Tail Grip Assembly. (CNC components)
2 x MR63-W2
Radial Bearing 3X6X2
Tail Hub Assembly. (CNC components)
SCM3X3 Set Screw M3X3
(loctite will be added
to the set screw during
the tail assembly step)
2 x OXY0050
Linkage Ball
4 X 3 M2
Page 5
OXY0063
Tail Pitch Slider
Half Moon
2 x MF74-ZZ
Flange Bearings
4x7x2.5
Thrust Washer(Larger ID)
OXY0053
Washer 4.2X6X0.2
OXY0054
3x4x0. 1 Shim Washer
OXY0049
Tail Hub
OXY0054
3x4x0. 1 Shim Washer
Note: each side
of the the hub
OR-2X1
O-RING ID 2 - W1
Note: each side
of the hub
Step 2
2 x OXY0064
Link Control
Important Note:
This part comes pre assembled
WITHOUT thread lock. Follow
the instruction for final assembly.
Ensure thread lock does not
contaminate the bushings. In
case of friction, clean then
reassembly.
F3-6G-W3.5
Thrust Bearing 3x6 W3.5
Thrust Washer(Smaller ID)
2 x OXY0051
Tail Grip 2 x OXY0055
Shim Washer
2X3.5 W 0.5
2 x TCEM2X5
Hex Cap Screw
M2X5
Chapter 5, Tail Assembly
2 x Bushing
2 X 3 H2
2 x TBEM2X5
Button Hex Cap
Screw M2X5
Important Note:
This part, for tuning reasons,
comes factory pre assembled
with grease and loctite. It is
ready to use.
Important Note:
This part comes pre assembled
WITHOUT thread lock. Follow
the instruction for final assembly.