Unpacking & Assembly - Garden Trax Y2007 Instructions Manual

UNPACKING & ASSEMBLY
Unpack your unit by carefully li ing it out of its
container. Remove any packing material and cut
any plas c es holding the handlebar pieces to
the rest of the assembly.
ASSEMBLY
1. Stand the unit upright with the nes and
wheels on a level surface. Do not elevate
the unit to a high surface where it could fall
and damage property or cause injury
2. Using two tee handle nuts, two bolts and
two curved washers, assemble the "U"
shaped middle handlebar
lower handlebar sec on already a ached to
the main assembly (See Figure 1).
middle handlebar
either a low or high posi on
DO NOT OVERTIGHTEN TEE HANDLE NUTS
3. A ach the upper right and l
the handlebars to the "U" shaped middle
on using the two remaining tee handle
nuts, bolts and curved washers (See Figure
1).
DO NOT OVERTIGHTEN TEE HANDLE NUTS
4. The drag stake is shipped on the unit with
the point facing upwards. Before using, you
will need to remove the detent pin turn the
it around so that the point is facing down.
5. Reinsert detent pin (See Figure 2).
on to the
The
on can be installed in
por ons of
MODEL Y2007
MINI CULTIVATOR AND DETHATHER
Y4000.02.01
Y4000.02-04A
Y4000.07
FIGURE 1
BOLT，HANDLE CLAMP
WASHER
Y4000.02-02A
Y4000.02-03A
Y4000.02.01
WASHER
BOLT，HANDLE CLAMP
DETENT PIN
FIGURE 2
8