Maintenance; Operation - Garden Trax Y2007 Instructions Manual

MAINTENANCE

STEPS FOR WORKING ON EQUIPMENT
1. Make sure engine switch is in the off position
2. Disconnect the Spark Plug wire from the Spark Plug
3. Secure the Spark Plug wire away from the Spark Plug itself and other metal parts. Make sure this is done to
prevent wire from arcing with Plug
4. Replace or repair parts on your unit
5. Once complete, make sure all parts are secure and fit correctly
NOTE: All parts must come from the factory or our authorized Service Center. Never use parts that
are not designed specifically for the unit
6. Once complete, reattach the Spark Plug wire
MINI CULTIVATOR MAINTENANCE
1. The unit Transmission Case comes with grease that has been packed at the factory. It is recommended by the
factory that the grease level be checked by a qualified service professional to ensure that the grease level is
accurate. If grease is needed, add only molylithium type grease only if the level is below the top of the gears. DO
NOT OVERFILL!
2. Make sure all screws, nuts and bolts are secure and tight
3. Store the unit in a safe cool environment for cold weather operation. Transferring the unit from cold to warm
environments can cause condensation build up
ENGINE MAINTENANCE
Cooling Fins, Air Vents and linkages must always be kept free of dirt and debris. Always make sure they are clean
●
before each time you use the unit
Never Run this unit without the engine Air Filter properly installed. Engine failure and additional wear may occur
●
if air cleaner is not installed properly
Service the Air Filter every 90 days or after 20 or more hours of operation. Clean Air filter on a daily basis in
●
dry, dusty, or other extreme conditions. If dust is visible in the air while the machine is in operation, the air filter
should be cleaned.
CAUTION!
PRACTICE SAFETY AT ALL TIMES!!!! ENGINE MUST BE TURNED OFF AND ALLOWED TO COOL AND SPARK
PLUG WIRE MUST BE DISCONNECTED WHENEVER WORKING ON UNIT FOR MAINTENANCE OR REPAIR
TO PREVENT ACCIDENTAL STARTING:
ENGINE MUST BE TURNED OFF AND ALLOWED TO COOL AND SPARK PLUG WIRE MUST BE DISCONNECTED
BEFORE CHECKING OR ADJUSTING ENGINE
MUFFLER AND NEARBY AREA TEMPERATURES MAY EXCEED 150° F (65° C). AVOID THESE AREAS
ALWAYS CHECK UNIT FOR LOOSE SCREWS AND BOLTS. KEEP CONNECTIONS SECURE
NEVER STORE UNIT INDOORS WITH FUEL IN THE TANK. FUEL VAPORS MAY BE PRESENT
ONLY ADULTS SHOULD BE ALLOWED TO USE UNIT OR PREFORM MAINTENANCE ON IT
ENGINE MUST BE TURNED OFF AND SPARK PLUG WIRE DISCONNECTED BEFORE ANY REPAIRS OR
MAINTENANCE IS PREFORMED ON UNIT
MODEL Y2007
MINI CULTIVATOR AND DETHATHER
12