Garden Trax Y2007 Instructions Manual page 11

COLD ENGINE STARTING CONTINUIED
3. Move choke lever to choke position
NOTE: In the choke position, always move the lever to the Farthest choke position possible
4. Push rocker switch to the ON position
5. Squeeze the throttle control with the right hand. Grasp the starter rope handle and pull out slowly until the tension
becomes slightly harder. Without letting the rope retract, pull the starter rope with a rapid, forearm stroke. Allow
rope to return to its original position. Repeat step until unit engages and allow rope to return to original position
each time it is engaged
NOTE: If the engine fails to engage after trying for 5 to 6 pulls, press the primer bulb 1 time and repeat process
6. Once the engine is engaged and has started running, move the choke lever to the half-choke position until engine
runs smoothly
NOTE: Half-Choke position is defined as being half way between Choke and Run
7. Once unit is running smoothly, move lever to the RUN position and engage throttle to the desired speed
NOTE: Do not let the unit idle for extended periods of time. Always run at FULL throttle speed when possible
8. In order to stop unit, move rocker switch to the OFF position
WARM ENGINE STARTING
1. Move the Choke Lever to the Choke position
NOTE: Choke position is defined as moving the lever to the farest Choke position possible
2. Continue by repeating Cold Engine Starting beginning with Step 4
HOT ENGINE STARTING
1. Begin with Step 4 of Cold Engine Starting
2. If engine does not start, refer to Step 1 of Warm Engine Starting
MODEL Y2007
MINI CULTIVATOR AND DETHATHER
11