Configure Wep - D-Link DWR-111 User Manual

Section 4 - Security
It is recommended to enable encryption on your wireless router before your
wireless network adapters. Please establish wireless connectivity before
enabling encryption. Your wireless signal may degrade when enabling
encryption due to the added overhead.
1. Log into the Web-based configuration by opening a web browser and
entering the IP address of the router (192.168.0.1). Click on Wireless
Settings on the left side.
2. Next to Security Mode, select WEP Security.
3. Next to Authentication, select Open or Shared Key.
4. Select either 64-bit or 128-bit encryption from the drop-down box
next to WEP encryption.
5. Next to Default WEP Key, select either Hex or ASCII.
Hex (recommended) - Letters A-F and numbers 0-9 are valid.
ASCII - All numbers and letters are valid.
6. Next to WEP Key, enter a WEP key that you create. Make sure you
enter this key exactly on all your wireless devices. You may enter up
to 4 different keys.
7. Click Save Settings to save your settings. If you are configuring the
router with a wireless adapter, you will lose connectivity until you
enable WEP on your adapter and enter the same WEP key as you did
on the router.
D-Link DWR-111 User Manual

Configure WEP

56