Yamaha 2011 Star XV250A Owner's Manual page 72

PERIODIC MAINTENANCE AND ADJUSTMENT
1. Wheel axle
2. Front wheel axle pinch bolt
3. Lift the front wheel off the ground
according to the procedure on
page 7-35.
4. Pull the wheel axle out, and then
remove the wheel. NOTICE: Do
not apply the brake after the
7
wheel has been removed to-
gether with the brake disc, oth-
erwise the brake pads will be
forced shut.
[ECA11071]
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the pro-
jections mesh with the slots.
1. Speedometer gear unit
2. Lift the wheel up between the fork
legs.
TIP
Make sure that there is enough space
between the brake pads before insert-
ing the brake disc and that the slot in
the speedometer gear unit fits over the
retainer on the fork leg.
EAU24933
7-36
1. Speedometer gear unit
2. Retainer
3. Speedometer cable
3. Insert the wheel axle.
4. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
5. Tighten the wheel axle to the spec-
ified torque.
Tightening torque:
Wheel axle:
59 Nm (5.9 m·kgf, 43 ft·lbf)
6. Tighten the front wheel axle pinch
bolt to the specified torque.
Tightening torque:
Front wheel axle pinch bolt:
20 Nm (2.0 m·kgf, 14 ft·lbf)