Adjusting The Brake Pedal Position; Adjusting The Rear Brake Light Switch - Yamaha 2001 V Star XVS1100AN Owner's Manual

XVS1100
a. Distance between brake pedal and footrest
Adjusting the brake pedal
position
The top of the brake pedal should be
positioned approximately
[XVS1100] or 98.5 mm [XVS1100A]
above the top of the footrest as shown.
Periodically check the brake pedal po-
sition and, if necessary, have a
Yamaha dealer adjust it.
PERIODIC MAINTENANCE AND MINOR REPAIR
XVS1100A
a. Distance between brake pedal and footrest
EAU01746*
WARNING
@
A soft or spongy feeling in the brake
pedal can indicate the presence of
82 mm
air in the hydraulic system. If there
is air in the hydraulic system, have a
Yamaha dealer bleed the system be-
fore operating the motorcycle. Air in
the hydraulic system will diminish
the braking performance, which
may result in loss of control and an
accident.
@
1. Brake light switch
2. Brake light switch adjusting nut
EW000109
Adjusting the rear brake light
switch
The rear brake light switch, which is ac-
tivated by the brake pedal, is properly
adjusted when the brake light comes
on just before braking takes effect. If
necessary, adjust the brake light switch
as follows.
Turn the adjusting nut while holding the
rear brake light switch in place. To
make the brake light come on earlier,
turn the adjusting nut in direction a. To
make the brake light come on later,
turn the adjusting nut in direction b.
6-18
EAU00713
6