Checking And Lubricating The Cables; Checking And Lubricating The Throttle Grip And Cable - Yamaha 2001 V Star XVS1100AN Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
Checking and lubricating the
cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the ca-
bles and cable ends should be lubricat-
ed if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
Recommended lubricant:
Engine oil
6
WARNING
@
Damage to the outer sheath may in-
terfere with proper cable operation
and will cause the inner cable to
rust. Replace a damaged cable as
soon as possible to prevent unsafe
conditions.
@
EAU02962
Checking and lubricating the
throttle grip and cable
The operation of the throttle grip and
the condition of the throttle cable
should be checked before each ride,
and the cable should be lubricated or
replaced if necessary.
NOTE:
_
Since the throttle grip must be removed
to access the throttle cable end, the
throttle grip and the cable should al-
ways be lubricated at the same time.
_
EW000112
1. Remove the throttle grip by remov-
ing the screws.
2. Hold up the throttle cable, and
then apply several drops of oil to
the cable, allowing it to trickle into
the sheaths.
3. Grease the inside of the throttle
grip housing.
EAU03764 4. Grease the metal-to-metal contact
6-21
surface of the throttle grip, and
then install the grip by installing
the screws.
Recommended lubricant:
Throttle cable:
Engine oil
Throttle grip housing and grip:
Lithium-soap-based grease
(all-purpose grease)