Yamaha 2004 WR250FS Owner's Service Manual page 75

THROTTLE CABLE ADJUSTMENT
1
2
3 - 10
2. Adjust:
• Clutch lever free play
Clutch lever free play adjustment steps:
• Loosen the locknuts 1.
• Adjust the free play by changing their tight-
ening position.
• Tighten the locknuts.
NOTE:
• Make minute adjustment on the lever side
using the adjuster 2.
• After adjustment, check proper operation of
clutch lever.
THROTTLE CABLE ADJUSTMENT
1. Check:
• Throttle grip free play a
Out of specification → Adjust.
Throttle grip free play a:
3 ~ 5 mm (0.12 ~ 0.20 in)
2. Adjust:
• Throttle grip free play
Throttle grip free play adjustment steps:
• Slide the adjuster cover.
• Loosen the locknut 1.
• Turn the adjuster 2 until the specified free
play is obtained.
• Tighten the locknut.
NOTE:
Before adjusting the throttle cable free play,
the engine idle speed should be adjusted.
WARNING
After adjusting the throttle cable free
play, start the engine and turn the han-
dlebar to right and left and make sure
that the engine idling does not run faster.
INSP
ADJ