Yamaha 2004 WR250FS Owner's Service Manual page 249

È
È
É
FRONT BRAKE AND REAR BRAKE
É
3. Install:
• Spring 1
To brake master cylinder piston 2.
NOTE:
Install the spring at the smaller dia. side.
È Front
É Rear
4. Install:
[Front]
• Brake master cylinder kit 1
• Washer 2
• Circlip 3
• Brake master cylinder boot 4
To brake master cylinder 5.
[Rear]
• Brake master cylinder kit 1
• Push rod 2
• Circlip 3
• Brake master cylinder boot 4
To brake master cylinder 5.
NOTE:
• Apply the brake fluid on the brake master cyl-
inder kit.
• Apply the lithium soap base grease on the tip
of the push rod.
• When installing the circlip, use a long nose
circlip pliers.
È Front
É Rear
Front brake master cylinder
1. Install:
• Brake master cylinder 1
• Brake master cylinder bracket 2
• Bolt (brake master cylinder bracket) 3
NOTE:
• Install the bracket so that the arrow mark a
face upward.
• First tighten the bolts on the upper side of the
brake master cylinder bracket, and then
tighten the bolts on the lower side.
5 - 21
CHAS
9 Nm (0.9 m · kg, 6.5 ft · lb)