Toyota 2008 Corolla Owner's Manual page 215

NOTICE
z Do not use liquid sealants for a flat
tire as tire pressure warning valve
and transmitter will be damaged.
z When the tires must be repaired or
replaced, have them repaired or re-
placed by the nearest Toyota dealer
or authorized tire dealer. The tire
pressure warning valves and trans-
mitters will be affected by
installation or removal of tires.
'08 Corolla_U (L/O 0706)
the
IF THE TIRE PRESSURE
LIGHT COMES ON AFTER BLINKING
FOR 1 MINUTE...
If the tire pressure warning light comes
on after blinking for 1 minute when the
ignition key is turned to the "ON" posi-
tion, the tire pressure warning system
is not working properly.
The system will be disabled in the follow-
ing conditions:
(When the condition becomes normal, the
system will work properly.)
D
If tires not equipped with tire pressure
warning valves and transmitters are
used.
D
If the ID code on the tire pressure
warning valves and transmitters is not
registered in the tire pressure warning
ECU.
D
If the tire inflation pressure is more
than 500 kPa (5.1 kgf/cm
psi).
The system may be disabled in the follow-
ing conditions:
(When the condition becomes normal, the
system will work properly.)
D
If electronic devices or facilities using
similar radio wave
nearby.
WARNING
D
If a radio set at similar frequencies is
in use in the vehicle.
D
If a window tint that affects the radio
wave signals is installed.
D
If there is a lot of snow or ice on the
vehicle, in particular around the wheels
or wheel housings.
D
If non−genuine Toyota wheels are used.
D
If tire chains are used.
2008 COROLLA from Aug. '07 Prod. (OM12B28U)
2
or bar, 73
frequencies are
127