Toyota 2008 Corolla Owner's Manual page 158

To install the infant seat:
1. Run the lap and shoulder belt through
or around the infant seat following the
instructions provided by its manufactur-
er and insert the tab into the buckle
taking care not to twist the belt. Keep
the lap portion of the belt tight.
70
'08 Corolla_U (L/O 0706)
CAUTION
D
After inserting the tab, make sure
the tab and buckle are locked and
that the lap and shoulder portions
of the belt are not twisted.
D
Do not insert coins, clips, etc. in
the buckle as this may prevent your
child from properly latching the tab
and buckle.
D
If the seat belt does not function
normally, it cannot protect
child from death or serious injury.
Contact your Toyota dealer immedi-
ately. Do not install the
restraint system on the seat until
the seat belt is fixed.
your
2. Fully extend the shoulder belt to put it
in the lock mode. When the belt is
child
then retracted even slightly, it cannot
be extended.
To hold the infant seat securely, make
sure the belt is in the lock mode before
letting the belt retract.
2008 COROLLA from Aug. '07 Prod. (OM12B28U)