Toyota 2008 Corolla Owner's Manual page 109

—Automatic door locking and
unlocking functions
Vehicles with automatic transmission
and power door lock system—You can
select the following modes
automatic locking and unlocking
functions.
D
Mode 1—Automatic locking
with the shift position
All doors are automatically locked when
the selector lever is moved out of the
"P" position with the ignition switch in
the "ON" position and all the doors are
closed.
D
Mode 2—Functions cancelled
Automatic door locking and unlocking
functions do not activate in this mode.
D
Mode 3—Automatic locking and un-
locking linked with the shift position
Locking function—All doors are auto-
matically locked when the selector le-
ver is moved out of the "P" position
with the ignition switch in the "ON"
position and all doors are closed.
Unlocking function—All doors are auto-
matically unlocked when the selector
lever is moved to the "P" position with
the ignition switch in the "ON" position.
D
Mode 4—Automatic locking and un-
locking linked with the shift position
of the and ignition switch
Locking function—All doors are auto-
matically locked when the selector le-
linked ver is moved out of the "P" position
with the ignition switch in the "ON"
position and all doors are closed.
Unlocking function—All doors are auto-
matically unlocked when the ignition
switch is turned from the "ON" position
to the "ACC" or "LOCK" position.
CHANGING THE MODE
The mode toggles through from mode
1 to mode 4. To change the mode, do
the following:
1. Set the interior light switch to the
"DOOR" position. (See "Interior light"
on page 93 in Section 1−5.)
2. Shift the selector lever into the "P"
position and close all doors.
3. Turn the ignition switch to the "ON"
position.
4. Within 5 seconds after
switch is turned to the "ON" position,
push and hold the power door lock
switch on the front side for about 5
seconds.
'08 Corolla_U (L/O 0706)
5. The interior light will flash to indicate
that the mode has been changed.
The flashing of the interior light indicates
the mode which has been selected.
D
Flashing
changed to mode 1.
D
Flashing
changed to mode 2.
D
Flashing three times, the function has
changed to mode 3.
D
Flashing four times, the function has
changed to mode 4.
If the battery is disconnected or run down,
the mode may change. Set the desired
mode by following the above procedure.
the ignition
2008 COROLLA from Aug. '07 Prod. (OM12B28U)
once, the function has
twice, the function has
21