Replacing The Headlight Bulb - Yamaha 2008 WR250X Owner's Manual

Replacing the headlight bulb

This model is equipped with a quartz
bulb headlight. If the headlight bulb
burns out, replace it as follows.
NOTICE
Do not touch the glass part of the
headlight bulb to keep it free from
oil, otherwise the transparency of
the glass, the luminosity of the bulb,
and the bulb life will be adversely af-
fected. Thoroughly clean off any dirt
and fingerprints on the headlight
bulb using a cloth moistened with al-
cohol or thinner.
1. Do not touch the glass part of the bulb.
1. Remove the headlight cowling to-
PERIODIC MAINTENANCE AND ADJUSTMENT
EAU45212 gether with the headlight unit by
removing the bolts and pulling up-
ward as shown.
1
ECA10660
1. Bolt
2. Disconnect the headlight coupler,
and then remove the bulb cover.
1. Headlight coupler
2. Bulb cover
1
1. Headlight bulb holder
1
2
7-34
3. Unhook the headlight bulb holder,
and then remove the burnt-out
bulb.
1
4. Place a new headlight bulb into po-
sition, and then secure it with the
bulb holder.
5. Install the headlight bulb cover,
and then connect the coupler.
6. Install the headlight cowling (to-
gether with the headlight unit) by
placing it in the original position,
and then installing the bolts.
7. Have a Yamaha dealer adjust the
headlight beam if necessary.
2
3
4
5
6
7
8
9