Toyota 2003 Tundra Owner's Manual page 144

Compact disc player
Push and hold " " (preset button 6) or
" " (preset button 5) to fast forward or
reverse within a compact disc. When you
release the button, the compact disc play-
er will resume playing.
AM
Push the "AM" button to turn on the radio
and select the AM band. "AM" will appear
on the display.
AUDIO CONTROL (Tone and sound bal-
ance adjustment function)
Each time you push the
CONTROL" knob, the mode changes. To
adjust the tone and balance, turn the
knob.
BAS: Adjusts low–pitched tones. The dis-
play ranges from –5 to 5.
MID: Adjusts mid–pitched tones. The dis-
play ranges from –5 to 5.
TRE: Adjusts high–pitched tones. The dis-
play ranges from –5 to 5.
FAD: Adjusts the sound balance between
the front and rear speakers. The display
ranges from F7 to R7.
144
BAL: Adjusts the sound balance between
the right and left speakers. The display
ranges from L7 to R7.
DISC (Compact disc)
Push the "DISC" button to play a compact
disc.
When the audio system is set into com-
pact disc operation, the display shows the
track, or track and disc number currently
being played.
Error messages
If the player malfunctions, your audio sys-
tem will display one of the six following
"AUDIO
error messages.
"WAIT": The compact disc player unit
may be too hot. Allow the player to cool
down.
"ERROR 1": The disc may be dirty, dam-
aged or inserted incorrectly
down). Clean the disc and re–insert it.
"NO DISC": The compact disc changer of
separate unit is empty. Insert a disc.
"ERROR 3": There is a problem inside
the system. Eject the disc or magazine.
Set the disc or magazine again.
"ERROR 4": Over–current.
Toyota dealer to inspect.
'03 TUNDRA_U (L/O 0301)
"CD OPEN": The compact disc changer
lid of separate unit is open. Close the
compact disc changer lid.
If the malfunction still exists, take your
vehicle to your Toyota dealer.
DISC
Use these buttons to select a disc you
want to listen to.
Push " " (preset button 3) or " " (preset
button 4) until the number of the disc you
want to listen appears on the display.
Dolbyr
If you are listening to a tape that was
recorded with Dolbyr B Noise Reduction,
push " " (preset button 3). "
appear on the display. Push the button
again to turn off Dolbyr B NR.
The Dolby NR mode reduces tape noise
(up–side
by about 10 dB. For best sound reproduc-
tion, play your tapes with this button on
or off according to the mode used to re-
cord the tape.
∗
: Dolby noise reduction manufactured under license from
Dolby Laboratories Licensing Corporation. "DOLBY" and the
double D symbol
Licensing Corporation.
Ask your
2003 TUNDRA from Jan. '03 Prod. (OM34421U)
∗
B NR
" will
are trademarks of Dolby Laboratories