Toyota 2003 Tundra Owner's Manual page 124

TURNING THE SYSTEM ON
To operate the cruise control, press the
"ON–OFF" button. This turns the system
on. The indicator light in the instrument
panel shows that you can now set the
vehicle at a desired cruising speed. Anoth-
er press will turn the system completely
off.
CAUTION
To avoid accidental cruise control en-
gagement, keep the "ON–OFF" button
off when not using the cruise control.
124
'03 TUNDRA_U (L/O 0301)
SETTING AT A DESIRED SPEED
On vehicles with automatic transmission,
the transmission must be in "D" before
you set the cruise control speed.
Bring your vehicle to the desired speed,
push the lever down in the "– SET" direc-
tion and release it. This sets the vehicle
at that speed. If the speed is not satisfac-
tory, tap the lever up for a faster speed,
or tap it down for a slower speed. Each
tap changes the set speed by 1.6 km/h
(1.0 mph). You can now take your foot off
the accelerator pedal.
If you need acceleration—for example,
when passing—depress
pedal enough for the vehicle to exceed
the set speed. When you release it, the
vehicle will return to the speed set prior
to the acceleration.
CAUTION
For manual transmission:
While driving with the cruise control
on, do not shift to neutral without
depressing the clutch pedal, as this
may cause engine racing or over–rev-
ving.
CANCELLING THE PRESET SPEED
You can cancel the preset speed by:
a. Pulling the lever
direction and releasing it
b. Depressing the brake pedal
c. Depressing the clutch pedal (manual
transmission)
If the vehicle speed falls below about 40
km/h (25 mph), the preset speed will auto-
matically cancel out.
If the vehicle speed drops 16 km/h (10
mph) below the preset speed, the preset
speed will also automatically cancel out.
2003 TUNDRA from Jan. '03 Prod. (OM34421U)
the accelerator
in the "CANCEL"