Toyota 2003 Tundra Owner's Manual page 119

(a) Front drive control (button
type)
'03 TUNDRA_U (L/O 0301)
Use the "2WD/4HI" and "4LO" buttons
to select the following transfer modes.
1. "2WD" (high speed position, two–
wheel drive): "2WD/4HI" and "4LO"
buttons left out
Use this for normal driving on dry,
hard–surfaced roads. This
gives greater economy, the quietest
ride and least wear.
2. "4HI" (high speed position,
wheel drive): "2WD/4HI" button pushed
in
The "4HI" (high speed four–wheel
drive) indicator light comes on when
the "4HI" mode is selected.
Use this for normal driving on wet, icy
or snow–covered roads. This position
provides greater traction than
wheel drive.
3. "4LO" (low speed position,
wheel drive): With the "2WD/4HI"
button pressed in, push the "4LO"
button
The "4LO" (low speed four–wheel drive)
indicator light comes on when
"4LO" mode is selected.
Use this for maximum power and trac-
tion. Use "4LO" mode for climbing or
descending steep hills, off–road driving,
and hard pulling in sand, mud or deep
snow.
See "(c) Shifting procedure (button type)"
for further instructions.
position
four–
two–
four–
the
2003 TUNDRA from Jan. '03 Prod. (OM34421U)
119