Clutch Lever Free Play Adjustment; Brake Light Switch Adjustment - Yamaha 2001 YZF-R6M Owner's Manual

PERIODIC MAINTENANCE AND MINOR REPAIR
1. Adjusting bolt
A. Free play
Clutch lever free play
adjustment
The clutch lever free play should be ad-
6
justed to 10 ~ 15 mm.
1. Turn the adjusting bolt at the
clutch lever in direction a to in-
crease free play or in direction b
to decrease free play. If the speci-
fied free play cannot be obtained,
proceed with the following steps.
2. Turn the adjusting bolt at the
clutch lever in direction a to loos-
en the cable.
1. Locknut
2. Adjusting nut
3. Remove cowling A. (See page 6-6
EAU01356
for removal and installation proce-
dures.)
4. Loosen the locknut at the crank-
case side.
5. Turn the adjusting nut at the
crankcase in direction a to in-
crease free play or in direction b
to decrease free play. Then tight-
en the locknut.
6. Install the cowling.
1. Brake light switch
2. Adjusting nut

Brake light switch adjustment

The rear brake light switch is activated
by the brake pedal and is properly ad-
justed when the brake light comes on
just before braking takes effect. To ad-
just the rear brake light switch, hold the
switch body so it does not rotate while
turning the adjusting nut.
Turn the adjusting nut in direction a to
make the brake light come on earlier.
Turn the adjusting nut in direction b to
make the brake light come on later.
6-25
EAU00713