Yamaha 2008 WR250XX Owner's Manual page 24

INSTRUMENT AND CONTROL FUNCTIONS
4. Push either select button to set the
minutes.
5. Push the "RESET" button, and the
second digits will start flashing.
1 6. Push either select button to set the
second digits to zero.
7. Push the "RESET" button for at
2
least two seconds, and then re-
lease it to start the clock.
3
NOTE:
If the "RESET" button is not pushed
4
within 30 seconds, the clock will not be
set and will return to the prior time.
5
Changing from the basic mode to
6
the measurement mode
With the odometer selected, push the
"SELECT 1" button and "SELECT 2"
7
button together for at least two seconds
to change to the measurement mode.
8
Changing from the measurement
9 mode to the basic mode
NOTE:
The stopwatch must be stopped before
changing to the basic mode.
1. Check that the stopwatch is not in
operation. If the stopwatch is in op-
eration, stop it by pushing the
"SELECT 1" button and "SELECT
2" button together.
2. Push the "SELECT 1" button and
"SELECT 2" button together for at
least two seconds to change to the
basic mode.
Measurement mode (for the stop-
watch)
When the measurement mode is se-
lected, the stopwatch is displayed and it
can be started manually or automatical-
ly.
Manual start
The manual start is the default setting
for the stopwatch. The stopwatch indi-
cator " " and the distance-compensa-
tion tripmeter indicator "
flashing.
3-6
1. Push the "RESET" button to start
the stopwatch.
2. Push the "SELECT 1" button and
"SELECT 2" button together to
stop the stopwatch.
3. To resume stopwatch counting,
push the "SELECT 1" button and
"SELECT 2" button together.
To reset the stopwatch to zero,
see "Resetting the distance-com-
pensation tripmeter or the dis-
" will start
tance-compensation tripmeter in
combination with the stopwatch"
on page 3-7.
NOTE:
The stopwatch will continue counting
when the vehicle is stopped. To stop
and/or resume counting, repeat steps 2