KVH Industries TracPhone V7 User Manual page 27

TracPhone V7 User's Guide
Chapter 3 - Configuration
Defining an RF Radiation Hazard Zone
24
Follow the steps below to configure an RF radiation hazard zone.
1. Determine the necessary azimuth range for the RF
hazard zone. You will need to enter the beginning and
ending azimuths that define the outer boundaries of the
zone, relative to the antenna's forward arrow, which
should be pointing toward the bow (see Figure 3-2).
NOTE: Each RF hazard zone must span at least 5º. Therefore, be sure
to set beginning and ending azimuths at least 5º apart.
Figure 3-2 Beginning and Ending Azimuths Defining RF Radiation Hazard Zone
335
Beginning
Azimuth
315
270
225
2. Press MENUS until the display shows
"CONFIGURATION."
CONFIGURATION
NEXT MENU
RF Radiation
Hazard Zone
(Example)
025
Ending
000
Azimuth
045
Forward
Antenna 090
135
180
ACCEPT