Remote Control; Cd Player (Cd-640) - Yamaha MCR-640 Owner's Manual

TROUBLESHOOTING
■ iPod
Note
If a transmission error occurs but no status message is displayed on the front panel display of the receiver, check the connection between
the receiver and your iPod (☞p.10).
Status message
CONNECT ERR
UNKNOWN TYP
CONNECTED
NOT CONNECT
CAN'T PLAY

Remote control

Problem
The remote control
does not work nor
function properly.

CD player (CD-640)

Problem
Power does not turn
on.
32
En
Cause
There is a problem with the signal path
from your iPod to the receiver.
The iPod being used is not supported by
the receiver.
Your iPod is properly stationed in the
iPod dock, and the connection between
your iPod and the receiver is complete.
Your iPod was removed from the iPod
dock of the receiver.
The receiver cannot play back the songs
currently stored on your iPod.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on this system
may be exposed to direct sunlight or
lightening (invented fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
this system and the remote control.
The system control cable is disconnected
from the system connector jack of the
receiver and/or the CD player.
Cause
The plug is not completely inserted.
The receiver and the CD player are
connected incorrectly.
The receiver is set incorrectly.
Remedy
Turn off the receiver and try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, iPod
Classic, iPod mini and iPod touch are supported.
Station your iPod back to the iPod dock of the
receiver.
Check that the songs currently stored on your iPod
are playable.
Store some other playable music files on your iPod.
Remedy
For information on the remote control operation
"Using the remote control"
range, see
Change the lighting or orientation of this system.
Replace the battery with new one.
Remove the obstacles.
Connect the receiver and the CD player securely with
the system control cable.
Remedy
Connect the power cable firmly.
Connect the system control cable properly between
the receiver and the CD player.
Check the setting (INPUT/Volume/MUTE/
Headphone) of the receiver.
See
page
10
—
10
—
—
See
page
11
.
11
11
11
8
See
page
8
8
—