Integra DTR-50.6 Advanced Manual page 28

Setting Item Default Value Setting Details
Back 7.0ft/2.10m Specify the distance between each speaker and the
listening position.
Surround Left 7.0ft/2.10m Specify the distance between each speaker and the
listening position.
Subwoofer 12.0ft/3.60m Specify the distance between each speaker and the
listening position.
Height Left 9.0ft/2.70m Specify the distance between each speaker and the
listening position.
Height Right 9.0ft/2.70m Specify the distance between each speaker and the
listening position.
When the speaker is set to "No" or "None" in "Speaker Configuration", the settings for "Speaker
Distance" cannot be changed.
Default values vary depending on the regions.
28
The setting is displayed if "Speaker
Configuration" - "Back" is set to other than
"None" and also "Back ch" is set to "1ch".
This setting cannot be changed when "Speaker
Settings" - "Powered Zone 2" is set to "Yes" and
Zone 2 is turned on.
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height Speakers Type"
is set to "Not Use".
– "Speaker Settings" - "Powered Zone 2" is set
to "Yes" and also Zone2 is set to on.
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Height Speakers Type"
is set to "Not Use".
– "Speaker Settings" - "Powered Zone 2" is set
to "Yes" and also Zone2 is set to on.
Level Calibration
Adjust the level of each speaker with the built-in test tone. Settings are automatically
configured if you use the Automatic Speaker Setup.
Setting Item Default Value
Front Left 0.0dB
Wide Left 0.0dB
Center 0.0dB
Wide Right 0.0dB
Front Right 0.0dB
Surround Right 0.0dB
Advanced Settings
Setting Details
Select a value between "-12.0dB" to "+12.0dB"
(in increments of 0.5dB). A test tone will be output
each time you change the value. Select the
desired level.
Select a value between "-12.0dB" to "+12.0dB"
(in increments of 0.5dB). A test tone will be output
each time you change the value. Select the
desired level.
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Front Speakers Type"
is set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes".
Select a value between "-12.0dB" to "+12.0dB"
(in increments of 0.5dB). A test tone will be output
each time you change the value. Select the
desired level.
Select a value between "-12.0dB" to "+12.0dB"
(in increments of 0.5dB). A test tone will be output
each time you change the value. Select the
desired level.
This setting cannot be changed in any of the
following cases.
– "Speaker Settings" - "Front Speakers Type"
is set to "Bi-Amp".
– "Speaker Settings" - "Powered Zone 2" is
set to "Yes".
Select a value between "-12.0dB" to "+12.0dB"
(in increments of 0.5dB). A test tone will be output
each time you change the value. Select the
desired level.
Select a value between "-12.0dB" to "+12.0dB"
(in increments of 0.5dB). A test tone will be output
each time you change the value. Select the
desired level.