Maintenance & Lubrication Charts; General; Lubrication Chart - Cushman Turf Truckster 84069 Parts & Maintenance Manual

7 MAINTENANCE & LUBRICATION CHARTS
7 MAINTENANCE & LUBRICATION CHARTS
7.1

GENERAL________________________________________________________________

!
WARNING
Before you clean, adjust, or repair this equipment,
disengage all drives, lower implements to the ground,
engage parking brake, stop engine and remove key
from ignition switch to prevent injuries
1. Always clean the grease fitting before and after
lubricating.
7.2

LUBRICATION CHART _____________________________________________________

Fitting Description
A Drive Shaft
B Upper Ball Joints
C Lower Ball Joints
D Tie Rod Ends
en-36
Qty
2
2
2
4
2. Lubricate with grease that meets or exceeds NLGI
Grade 2 LB specifications. Apply grease with a
manual grease gun and fill slowly until grease begins
to seep out. Do not use compressed air guns.
3. For smooth operation of all levers, pivot points and
other friction points that are not shown on the
lubrication chart apply several drops of SAE 30 oil
every 40 hours or as necessary.
4. Grease fittings every 100 hours. Do not over grease
drive shaft fittings (A). Too much grease will damage
the seals.
Fuse Box
A
Brake Fluid
Reservoir D
C
D
C
B