The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Siemens WM14E462GB series Instruction Manual And Installation Instructions

5. For models without a drain hose:
Carefully unscrew the pump cover
until the detergent solution begins to
flow out.
When the service flap is half full,
close the pump cover and drain the
service flap.
Repeat the above steps until all the
detergent solution has completely
drained out.
Carefully unscrew the pump cover;
6.
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Place the service flap back on, lock
7.
it into place, and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment II and start the
Empty/Drain programme.
Cleaning and maintenance
The drain hose at the siphon
is blocked
Switch off the appliance. Pull out the
1.
mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drain hose and siphon
3.
connecting piece.
Reattach the drain hose and secure
4.
the connection point using the hose
clamp.
Filter in the water supply
blocked
:
Warning
Risk of electric shock!
Do not immerse the Aqua-Stop safety
valve in water (it contains an electric
valve).
For this, first reduce the water pressure
in the supply hose:
Turn off the water tap.
1.
Select any programme (except
2.
Rinse / Spin / Drain/Empty).
Press the Start/Reload button. Allow
3.
the programme to run for
approximately 40 seconds.
Turn the programme selector to Off.
4.
Pull out the mains plug.
Clean the filter on the water tap:
5.
Remove the hose from the water tap.
Clean the filter with a small brush.
en
23