Programme Default Settings; Temperature °C; Spin Speed; Finished In - Siemens WM14E462GB series Instruction Manual And Installation Instructions

0
Programme default
settings
The temperature, spin speed and
P r o g r a m m e d e f a u l t s e t t i n g s
programme duration ("Finished in" time)
for all programmes are preset at the
factory.
These are displayed in the display panel
after selecting the programme.
You can change the default settings as
follows.
s Temperature °C
Depending on the programme
progress, you can change the preset
temperature (in °C) before and during
the programme.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
The maximum temperature that can be
set depends on the programme which
has been selected.
Overview of programmes ~ Page 12

0 Spin speed

Depending on the programme
progress, you can change the spin
speed (in rpm; revolutions per minute)
before and during the programme.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Setting 2 (without final spin), the
laundry remains in the water after the
final rinse.
You can select 2 (without final spin) to
prevent creasing if the laundry will not
be taken out of the washing machine
immediately after the programme has
ended.

Programme default settings

The maximum speed that can be set
depends on the model and programme
that have been selected.
Overview of programmes ~ Page 12

5 Finished in

When you select the programme, the
relevant programme duration is
displayed.
The programme duration is
automatically adjusted when the
programme is running. Changes to the
programme default settings or
programme settings also change the
programme duration.
Before starting the programme, the
programme end ("Finished in" time) can
be pre-selected in increments of one
hour (h = hours) up to a maximum of 24
hours.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
The programme duration is
Note:
included in the selected "Finished in"
time.
After the start, the preselected time e.g.
8 h is displayed and the time counts
down to the start of the wash
programme. The programme duration is
then displayed, e.g. 2:30
(hours:minutes).
Changing the preselected time:
You can change the preselected time
after the start of the programme as
follows:
Press the Finished in button
1.
repeatedly until the required number
of hours is displayed.
Press the Start/Reload button.
2.
en
15