Basic Safety Precautions Fire And Explosions; Keep Flames Away; Keep Engine Surrounding Area Tidy And Clean; Care For Fuel, Oil And Exhaust Gas Leakage - Mitsubishi S4S-DT Operation & Maintenance Manual

Chapter 1 BASIC SAFETY PRECAUTIONS
Fire and explosions

Keep flames away

Do not use flames near the engine (in
the engine room). Fuel vapor or other
gas can catch fire and produce dan-
gerous situations.
Wipe off spilled fuel, oil and LLC
immediately and thoroughly. Spilled fuel, oil and LLC
may ignite and cause a fire.
Store fuel and engine oil in a well-ventilated area.
Make sure that the caps of fuel and engine oil contain-
ers are tightly closed.
Keep engine surrounding area
tidy and clean
Do not leave combustible or explosive materials, such
as fuel, engine oil and LLC, near the engine. Such
substances can cause fire or explosion.
Remove dust, dirt and other foreign materials accu-
mulated on the engine and surrounding parts thor-
oughly. Such materials can cause fire or the engine to
overheat. In particular, clean the top surface of the
battery thoroughly. Dust can cause a short-circuit.
Care for fuel, oil and exhaust
gas leakage
If any fuel, oil or exhaust gas leakage is found, imme-
diately take corrective measures to stop it.
Such leakages, if left uncorrected, can cause fuel or
engine oil to reach hot engine surfaces or hot exhaust
gas to contact flammable materials, possibly leading
to personal injury and/or damage to equipment.
Use explosion-proof lighting
apparatus
When inspecting fuel, engine oil, coolant, battery elec-
trolyte, etc., use a flameproof light. An ordinary light-
ing apparatus may ignite gas and cause it to explode.
Prevent electrical wires from
short-circuiting
Avoid inspecting or servicing the electrical system with
the ground cable connected to the battery. Otherwise,
a fire could result from short-circuiting. Be sure to dis-
connect the battery cable from the negative (-) termi-
nal before beginning with the work procedure.
Short-circuits, possibly resulting in fire, may be
caused by a loose terminal or damaged cable/wire.
Inspect the terminals, cables and wires, and repair or
replace the faulty parts before beginning with the ser-
vice procedure.
Keep fire extinguishers and a
first-aid kit handy
Keep fire extinguishers handy, and
become familiar with their usage.
Keep a first-aid kit at the designated
place where it is easily accessible by
anyone at any time.
Establish response procedures to follow in the event
of fire or accident. Provide an emergency evacuation
route and contact points and means of communication
in case of emergency.
1-1