Table of Contents
Advertisement
FP-e Series
Optimised for a wide range of applications
Equipped with RS485 and RS232C interfaces
Up to 99 computer link stations are possible with
RS485.
(RS485 type)
Up to 32 computer link stations are possible using a
C-NET adaptor and up to 99 are possible using a
commercially available adaptor. You can easily
monitor operation status or perform control.
Computer link
Personal Computer
FP-e
RS232C
Commercially
available adaptor
RS485
Can even handle temperature control
Two-point K-type thermocouple (-30 to 300°C)
connection is possible.
(equipped with thermocouple input)
Can be used in place of a temperature controller or
used to control them.
FP-e
As
temperature
controller
Temperature
FP-e
controller, etc
As
a controller for
PV
temperature
SV
SV1
SV2
TX/RX
AT
controller
OUT
MODE
KT4
RS485
∗Compatible with MODBUS, it can be used as a slave.
Equipped with high-speed counter for support of 2-axis independent positioning
Pulse output function
The unit comes equipped with 2 channels for pulse
output of up to 10 kHz pulses.
Since these two channels can be separately controlled,
the FP-e is also suitable for 2-axis independent
positioning.
Pulse output
Y0
CW/CCW output
Y2
Pulse output
Y1
CW/CCW output
Y3
Clearwater Tech - Phone: 800.894.0412 - Fax: 208.368.0415 - Web: www.clrwtr.com - Email: info@clrwtr.com
With RS232C, communication with up to two ports
is possible.
FP-e
FP-e
PID instruction function
High-performance temperature control can be achieved
with PID instruction.
Temperature
controller, etc
PV
OUT1
OUT1
OUT2
OUT2
SV
A1
A1
EVT
EVT
SV1
SV2
TX/RX
AT
OUT
MODE
OFF
OFF
KT4
Up to 32
controllers
High-speed counter function
In single phase, the 4-channel total is 10 kHz, and in 2-
phase the 2-channel total is 2 kHz total speed, making
the FP-e suitable for inverter control, etc.
(One half for the type with thermocouple input.)
Motor
driver 1
Stepping motor
Servo motor
Motor
driver 2
(RS232C type)
Personal Computer
Image Processing
Device, etc.
COM
FLA
COM
RDY
ERR
REN
STR
FP-e
OVF
D1
D2
D3
D4
D5
D6
D7
D8
COM
STA
RS232C
RS232C
COM
FCT1
FCT2
ACK
TYP
IN1
IN2
Tool port
COM. port
IN3
IN4
IN5
IN6
IN7
IN8
+
-
Y0
PID instruction
Heater
Thermocouple input
A0
Cutter
Feeder roller
Inverter
Motor
START/STOP
Cutter blade
Encoder
signal
control signal
Input encoder
output into the
high-speed counter
POWER
ERROR
CF
READY
COM.1
TOOL
COM.2
KEYPAD
COM.1
CAMERA1
COM.2
MONITOR
CAMERA2
Lead wire
and tape
Advertisement
Table of Contents
