GE cafe Owner's Manual page 27

Troubleshooting tips ... Before you call for service
Problem
Top burners do not light
or do not burn evenly.
(The front right burner
is designed to have
slightly smaller flames
between the 6 and 9
o'clock positions. This
is normal.)
Burner flames very large
or yellow
Surface burners light
but oven does not
Burners do not light
Lock Controls or
Control Lockout feature
is activated
49-85233
Possible Cause
Plug on range is not
completely inserted in the
electrical outlet.
Burner slits on the side of
the burner may be clogged.
Improper burner assembly..
Improper air to gas ratio.
The oven gas shut-off valve
may have accidentally been
moved during cleaning or
moving.
Plug on range is not
completely inserted in the
electrical outlet.
Gas supply not connected or
turned on.
A fuse in your home may be
blown or the circuit breaker
tripped.
Burner parts not replaced
correctly.
What To Do
Make sure electrical plug is plugged into a live, properly
grounded outlet.
Remove the burners and clean them. Check the electrode area
for burned-on food or grease. See the Care and cleaning of the
range section.
Make sure the burner parts are installed correctly. See the
Care and cleaning of the range section.
installed your range or made the conversion.
drawer models, remove the rear access panel by unscrewing
the thumb screws in the upper left and right corners. Look for
the gas shut-off lever at the back of the range.
Lever is
shown closed.
PULL TO OPEN.
Sealed burner models
Make sure electrical plug is plugged into a live, properly
grounded outlet.
Replace the fuse or reset the circuit breaker.
See the Care and Cleaning of the range section.
LOC ON appears in the display, the range control is locked.
Turn this feature off to use the range. See the Lock Control
feature in the Oven Controls section.
Thumb screws
Lower oven drawer models
27