GE cafe Owner's Manual page 21

Cooktop (Cont.)
Cleaning The Burners
Burner Caps
Wash burner caps in hot, soapy water and rinse with
clean water. You may scour with a plastic scouring pad
to remove burned-on food particles. The round caps may
also be cleaned in your dishwasher.
Burner Heads
Wash the burner heads routinely, especially after bad
spillovers, which could clog the openings. Lift burners
off when cool. Use hot, soapy water. Rinse with clean
water. For more stubborn stains, use a brush with plastic
bristles.
NOTE: Do not use steel wool or scouring powders to
clean the burner parts as these may clog the parts.
Never wash burner heads in your dishwasher as
dishwasher detergents will discolor your burners.
The ports in the burner heads must be kept clean at all
times for an even, unhampered flame.
Clogged or dirty burner ports or electrodes will not allow
the burner to operate properly.
For proper ignition, make sure the small hole in the notch
that fits over the electrode is kept open. A sewing needle
or wire twist-tie works well to unclog it.
After cleaning
water and allow them to dry thoroughly.
Replacing Burner Heads
Replace burner heads in the correct locations according
to size.
Burner Caps
Replace burner caps on burner heads. Make sure each
cap fits securely and sits flat on its corresponding burner
head.
49-85233
Round hole in
burner head must
be kept clear
CAUTION
Do not operate the cooktop without
all burner parts and grates in place.
Any spill on or around an electrode must be carefully
cleaned. Take care to not hit an electrode with anything
hard or it could be damaged.
The electrode of the spark igniter is exposed
when the burner head is removed. When one
burner is turned to LITE, all the burners spark.
Do not attempt to disassemble or clean around
any burner while another burner is on. An electric
shock may result, which could cause you to
knock over hot cookware.
Burner cap is Burner cap is
NOT properly NOT properly
seated.
Electrode
or
Tri-ring base
Burner cap is
properly seated.
seated.
21