Table of Contents
Advertisement
Initial Settings
Adjusting initial settings
1
Initial settings lets you perform initial setup of
different settings for this unit.
1 Function display
Shows the function names.
1
Touch the source icon and then touch
OFF to turn this unit off.
# When the source icon is not displayed, you
can display it by touching the screen.
2
Touch A.MENU and then touch INITIAL
to display the function names.
The function names are displayed and oper
able ones are highlighted.
# When A.MENU is not displayed, you can dis
play it by touching the screen.
# You can also display MENU by clicking the
joystick.
# To go to the next group of function names,
touch NEXT.
# To return to the previous group of function
names, touch PREV.
# To return to the previous display, touch BACK.
# To return to the display of each source, touch
ESC.
Switching the warning tone
If the front panel is not detached from the
head unit within five seconds of turning off the
ignition, a warning tone will sound. You can
turn off the warning tone.
1
Touch A.MENU and INITIAL and then
touch DETACH WARNING.
2
Touch a to turn warning tone on.
# To turn warning tone off, touch b.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1
Touch A.MENU and INITIAL and then
touch AUX.
2
Touch a to turn auxiliary setting on.
# To turn auxiliary setting off, touch b.
Correcting distorted sound
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set
ting at HIGH to ensure quality sound.
1
Touch A.MENU and INITIAL and then
touch DIGITAL ATT.
2
Touch either of the following touch
panel keys to select the digital attenuator
setting.
! HIGH High quality sound
! LOW Minimize distortion sound
Section
17
89
En
Advertisement
Table of Contents
