Advertisement
INSTALLER AND OWNER GUIDE
the fireplace.
3. The top rear flange of the spacer frame has two screw locations. Mark the positions
of the two screw locations on the rear wall (See figure 7).
4. Remove the spacer frame from the fireplace
and place away from the work area.
5. Drill the screw locations using a no. 12
masonry drill bit.
6. Insert the two wall plugs provided into the
holes
7. Insert a screw into each hole and screw in until
there is approximately 6mm of screw protruding
from the wall.
Figure 7. Bracket positions
Preparing the heater for installation.
1. Using the four screws provided, fix the heater
to the spacer frame.
2. There is a supply cable slot on both sides of the
spacer frame. It is located at the base. Decide
which side to pass the supply cable through. The
nylon grommet supplied has a slot along its length.
Fit the grommet to the mains cable with the flange
edge positioned away from the fire (See figure 8).
4. Position the supply cable in the spacer frame slot
5. Slide the nylon grommet along the supply cable
Figure 8. Fitting the grommet
towards the heater. When the grommet reaches the
slot, push it into the slot up to its flange (See figure
8).
Fitting the heater.
1. Locate the spacer frame and heater over the screw heads ensuring a tight fit. If the fit
is loose, remove the spacer frame and heater from the wall. Tighten the wall screws
slightly and reposition the spacer frame and heater.
Page 9
Advertisement
