Advertisement
INSTALLER AND OWNER GUIDE
Before continuing any further with the installation of this heater please read the
following:
Important instructions.
The lifting weight of the heater is as below:
!
The fascia and Firefront weights are not included in the heat engine weight.
* A spacer is supplied with the Debut model. An optional spacer frame kit is
obtainable either from the your heater supplier or direct from Baxi Fires Division
Sales. The kit is a 75mm (3 inch) spacer kit (Kit number 05801T1).
One person should be sufficient to lift the heater. If for any reason this weight is
!
considered too heavy then obtain assistance.
When lifting always keep your back straight. Bend your legs and not your back.
!
Avoid twisting at the waist. It is better to reposition your feet.
!
Avoid upper body / top heavy bending. Always bend from the knees rather than
!
the waist. Do not lean forward or sideways whilst handling the heater.
Always grip with the palm of the hand. Do not use the tips of fingers for support.
!
Always keep the heater as close to the body as possible. This will minimise the
!
cantilever action.
Use gloves to provide additional grip.
!
Always use assistance if required.
!
Remove the spare bulb from the top polystyrene fitment.
!
Always
Always install the heater in accordance with this guide. If in doubt obtain
!
expert advice.
Always make sure the electrical socket is accessible and located adjacent to, but
!
not above the heater.
Always disconnect the heater from the electrical supply before carrying out
!
cleaning, maintenance or replacing the light bulbs.
Always make sure the heater is firmly secured to prevent it from being tipped over.
!
Always use a fireguard when young children and infirm persons can come into
!
HANDLING AND UNPACKING
Heat engine (kG)
6.8
SAFETY
Spacer (kG)
Page 3
2.3*
Advertisement
