Advertisement
INSTALLER AND OWNER GUIDE
Some models are not supplied with a spacer frame kit. This optional spacer frame kit is
obtainable either from the your heater supplier or direct from Baxi Fires Division Sales.
The kit is a 75mm (3 inch) spacer kit (Kit number 05801T1).
Important Electrical Safety
The heater must not be located in front of or under
an electrical socket, the socket must always be
accessible in order to disconnect the heater from the
electrical supply for maintenance and cleaning.
Important! This heater must be earthed.
The heater is supplied with a 3 pin 13 Amp fused
!
re-wireable plug with 1mm² 3 core cable.
The wires in the cable are coloured in
!
accordance with the following code: -
Live =Brown
Neutral = Blue
Earth = Green /Yellow
The mains supply must be safely routed from the
!
heater to an electrical socket.
Moving the Cable Guide
At the base of the heater you will find the electric
cable which runs through a rectangular plastic cable
guide. The cable guide is fitted into the rectangular
slot on the right side of the heater. If required this
can be moved and put in the rectangular slot in the
centre or left hand side of the heater. For removal
and fitting please see below.
Removing the cable guide
1. Before moving the cable guide please note that the
lip of the cable guide is on the outer edge of the base
(See figure 1- Item 1).
2. To remove the cable guide push and lift the tab on
the bottom of it and the cable guide will open (See
figure 1- Item 2).
3. Lift the electric cable clear of the cable guide.
4. Hold the bottom of the cable guide close to the
heater then gently pull the cable guide away from
the rectangular slot (See figure 1- Item 3).
Figure 1. Removing and
positioning the cable guide.
Page 5
Item 1
Item 2
Item 3
Item 4
Advertisement
