Advertisement
INSTALLER AND OWNER GUIDE
Fitting the cable guide.
When fitting the cable guide please remember that the lip of the cable guide has to be
fitted against the outer face of the base (See figure 1- Item 1).
1. Gently pinch the sides of the cable guide (See figure 1 - Item 4) and push into the
desired rectangular slot.
2. Place the electrical cable into the guide and close the top.
If the mains cable is damaged, to avoid a hazard it must be replaced by a Baxi fires
division authorised service agent, or similarly qualified person (See the last page of this
guide for useful telephone numbers).
All external wiring between the heater and the electrical supply shall comply with
current IEE regulations.
Heater Fixing
All of the fixings supplied with the heater have been identified as in figure 2.
Figure 2. Loose parts identification
The heater must be fixed into position to prevent it from being tipped over
The following fixing options are available:
Screw Fixing
Wire Fixing
Spacer Frame (The spacer frame may not be supplied with the heater - see details
in section headed '
If fitting the heater into a fireplace or surround opening, try the heater in the opening to
ensure that it will fit.
Where can I fit the heater?'
.
)
Page 6
Advertisement
