Advertisement
INSTALLER AND OWNER GUIDE
Fitting the fascia.
Important notes.
1. The coal pieces supplied are a natural
material. Occasionally it will be necessary to
reduce the size of the coal pieces. To do this
place them inside a plastic bag, place on a
suitable hard surface and tap gently with a
small hammer or similar tool.
2. The pebbles and coals are for decorative
purposes only. There is a choke risk to
young children. Make sure they cannot
gain access to them.
Fitting the fascia.
1. On Aura, Camden and Aura 2 heaters the
firefront assembly will require fitting before the
fascia. To do this align the four holes in the
firefront assembly with those on the heater. Secure
with the four screws supplied.
2. The fascia consists of three parts. Two sides
and a top. These are held in place with six
magnets. Lay the three fascia parts face down on a
flat surface as in figure 9. Each side trim has a
small tab at the top.
Position the tab to the
outside upper edge
(See figure 9).
3. Locate the tabs into
the fold on the top
edge of the top trim.
4. Locate the six
magnets on the side
trims as in figure 10.
Note that bottom edge
of the the upper
magnets are in line
with the bottom of the
top trim.
5. Lift the trims at the
top outer edges. This
Figure 11. (The fuel effect may
differ from that shown)
Page 10
Figure 9.
Figure 10.
Advertisement
