Maintenance And Servicing - Morso 553 Owner's Manual

Ceramic Fuel Pieces and Firebox Walls
This appliance uses firebox walls and fuel effect pieces containing Refractory Ceramic Fibres (RCF), which
are man-made vitreous silicate fibres. Excessive exposure to this material may cause temporary irritation to
eyes, skin and respiratory tract. Consequently, it makes sense to take care when handling these articles to
ensure that the release of dust is kept to a minimum.
Light coatings of soot will usually be burnt off during the normal operation of the fire. Should any soot
accumulation become excessive, the fuel effect pieces should be removed from the fire for cleaning. The
front and rear base coals are fragile and should be handled
carefully. Cleaning should be carried out in a well ventilated
area or in the open air by gently brushing with the pieces held
away from your face so that you avoid inhaling the dust. We
do not recommend the use of a normal domestic vacuum
cleaner which may blow dust back into the air. We suggest
that you remove the coals in the reverse order to that shown
in the fuel bed refitting instructions.
REFITTING THE CERAMIC WALLS &
FUEL PIECES
1. Place the ceramic walls against the firebox sides. Locate
the back edges of the walls in the tabs at the back
corners of the firebox. See figure 5.
2. Place the ceramic rear base coal in position. The front of
the coal must rest behind the two stops at the rear of the burner and not rest on top of
them. See figure 6.
3. Place the left front coal behind the metal lip
at the front of the burner. See figure 7.
4. Place the right front coal behind the metal
lip at the front of the burner. Its left side
should rest over the projection on the left
front coal. See figures 7 & 8.
5. The double top coals are marked "L" and
"R". Place the coal marked "L" behind the
front left coal. Place the coal marked "R"
behind the front right coal. Place the single
coal between the two double coals. See
figure 9.
7. Close and secure the windows by refitting the locking screw.
MAINTENANCE & SERVICING
Regular maintenance
In order to achieve and maintain high levels of personal safety and performance efficiency,
it is essential that the flue is kept clear of any form of obstruction.
In the United Kingdom it is the law that a landlord must have any gas appliance, flue and
pipework which is situated in a tenant's premises checked for safety at least every twelve
months by a competent person (In the U.K., a CORGI registered installer).
We recommend that all gas appliances and their flues, wherever situated, are checked annually.
Servicing
•
In the United Kingdom servicing can be carried out either by a Wonderfire Service engineer or a CORGI registered installer.
•
If you require your fire to be serviced by a Wonderfire Service engineer please contact the Wonderfire service department on
345 626 341 and quote the following details;
a) - model name and number.
b) - appliance serial no.
•
In Republic of Ireland call 353 183 75114 for all enquiries.
•
If you wish to replace any of the owner replaceable parts listed below, please contact your dealer or the Wonderfire service department
for your nearest stockist of these parts. When ordering please quote the part number shown below.
Description
Complete set of ceramic coals
Rear base coal piece
Left front base coal
Right front base coal
Bag of 3 top coal pieces
Complete set of ceramic walls
Ceramic left side wall
Ceramic right side wall
Allen key for window opening
Window securing screw
When fitting replacement parts, follow the instructions contained in this guide.
It is important that only approved parts are used for maximum safety.
Figure 8
Part No.
572579
572589
571019
571029
572599
572609
572619
572629
572639
572649
Figure 6
5
Figure 5
Figure 7
Figure 9