Battery And Sd Card Installation - Bushnell 119432CW Instruction Manual

BATTERY and SD CARD INSTALLATION

The Bushnell 119422CW/119432CW Digital Trail Camera is designed to
operate using 4 AA batteries. We recommend using Lithium (for longest
life) or Alkaline Energizer® batteries.
NOTE: Always set the power switch to the OFF position when installing or
removing batteries.
Please make sure the batteries are inserted correctly, as indicated inside
the battery compartment. Incorrect voltage or polarity (+/-) will damage
the camera.
Do not mix old and new batteries.
Do not mix battery types-use ALL lithium or ALL alkaline.
Rechargeable batteries are not recommended.
Memory
Your 119422CW/119432CW Digital Trail Camera has a memory card slot,
to accept SD cards up to 32GB max. capacity (sold separately).
Inserting an SD card
• Make sure the power switch is in the OFF position whenever adding
or removing memory.
• Insert an SD card into the card slot completely and oriented correctly
as shown by the icon above the slot (label up, contacts facing down
and notched corner on the right).
• To remove the SD memory card, depress the SD card and pull out
the card gently.
Using a new, blank SD card is recommended. If the SD card has been used
in another device, please make sure to format using the Format option
in the Trail Camera's Setup menu before you set the camera to capture
photos/videos. New cards are ready to use straight from the package.
8